The following is included:
Load carrying features
Your choice of shoulder straps – either S-shaped or J-shaped. These have a daisy chain and pockets can be added. Wide J-shaped with sewn-in pockets are available at an upcharge.
Frame consisting of two tubular aluminium frame stays. Frame length: short 46cm, medium 50cm, long 54cm & x-long 58cm.
Hip belt with 15mm of padding and a load-stiffening insert. The dual adjust forward pull closure means you can fine-tune the angle of tension.
Both the hip belt and frame are removable. There’s not much point to using the pack without either but it’s nice to be able to swap the hip belt sizes or replace a damaged part.
Integrated foam sit pad that doubles as upper back padding. The back pocket can take other pads up to 2cm in thickness.
The comfortable carrying range is up to 14kg.
Materials & pockets
Pack body made from EPLX200 with EPLX400 used for the back and bottom panels.
Ultra stretch front pocket.
Shaped side pockets that are accessible while wearing the pack. They can fit 2x 1L bottles each.
Straps
Light Y-shaped top strap.
The roll top has both snaps and buckles.
Single elastic side compression.
Measurements
The internal volume is the maximum usable capacity in the main compartment with 3 rolls on the rolltop – short 37L, medium 39L, long 41L & longer 43L. Pockets add up to 8L external capacity.
Unrolled length: short 78cm, medium 82cm, long 86cm & x-long 90cm
Circumference: bottom 81cm & top 90cm
Notes
A proper fit is key for a frame pack without load lifters. Be sure to measure your back length.
Most sizes can be used for carry-on, with the exception of X-long back length.
The pack is constructed from waterproof laminates and sewn with binding tape. A pack liner is always recommended for full waterproofing.